Repair Procedures: Removal

Turn the ignition switch off and disconnect the battery (-) terminal.
Remove variable charge motion actuator connector (A) and three mounting bolts.
Remove intake manifold vacuum pipe (B) in order to secure work space.

Fig 1: Removing Variable Charge Motion Actuator Connector And Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove VCMA rod clip (A) and connection link between flap (B) using screwdriver.

Fig 2: Removing VCMA Rod Clip And Connection Link
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- VCMA connection link can be damaged. So, make sure to remove it in a horizontal direction.
- Make sure that groove part of the connection link (C) is pointing upward when mounting VCMA.