Repair Procedures: Removal

Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.

Fig 1: Locating Drain Plug
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Replace the gasket before reinstalling the drain plug.
- After the installation, start the engine and then check if there are any leakages from the drain plug.
Remove the wiring mounting clip (A).
Disconnect the air breather hose (B) from the valve body cover.
Tightening torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Fig 2: Locating Air Breather Hose And Wiring Mounting Clip
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the hose (A) after removing the automatic transaxle fluid cooler hose clamp.

Fig 3: Locating Automatic Transaxle Fluid Cooler Hose
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Carefully install the clamp not to damage the hose.
- Install the clamp in a correct direction not to be interfered with other parts.
- After the installation, start the engine and then check if there are any leakages from the hose.
Remove the valve body cover (A).
Tightening torque:

11.8 - 13.7 N.m (1.2 - 1.4 kgf.m, 8.7 - 10.1 lb-ft)

Fig 4: Valve Body Cover Bolts
Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Locating Valve Body Cover
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Replace the gasket (A) before reinstalling the valve body cover.
  
  Fig 6: Locating Valve Body Cover Gasket
  Courtesy of HYUNDAI MOTOR AMERICA
- After the installation, start the engine and then check if there are any leakages from the valve body cover.
Disconnect the oil temperature sensor and solenoid valve connector (A) from the valve body.
Tightening torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Fig 7: Locating Oil Temperature Sensor And Solenoid Valve Connector
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Check for the looseness, poor connection, bending, corrosion, contamination, deterioration, or damage before reinstalling the solenoid valve connector.
Remove the valve body assembly (A).
Tightening torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 Ib-ft)

Fig 8: Locating Valve Body Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the input & output speed sensor connector (A).

Fig 9: Locating Input & Output Speed Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the input & output speed sensor (A) after removing the bolts (2 ea).
Tightening torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Fig 10: Locating Input & Output Speed Sensor
Courtesy of HYUNDAI MOTOR AMERICA