Repair Procedures: Replacement
WARNING: This page is about a different variant/trim than selected.
Information
TRANSFER FLUID CHANGE
| Change | |
|---|---|
| Normal Use | Severe Use |
| No service required | 120000 km (80000 miles) |
Severe driving conditions
- Driving in dusty, rough roads
- Driving in mountains areas
- Driving for patrol car, taxi, commercial car or vehicle towing
- Driving over 170 Km/h
* Transfer oil should be replaced if the transfer assembly is fall into the water.
- Remove the under cover (A).
- Drain the transfer oil after loosening the drain plug (A).
- Install the drain plug with new gasket.
Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0kgf.m, 43.4 ~ 57.9 lb-ft)
- Remove the oil filler plug (A).
- Add new oil through the filler plug hole.
Standard oil: Hypoid gear oil API GL-5, SAE 75W/90 (SHELL SPIRAX X or equivalent)
Oil capacity:
Gasoline 3.3: About 0.68 L (0.18 U.S.gal, 0.72 U.S.qt, 0.60 lmp.qt)
Information
- Filled up to lower filler plug thread level.
- Install the oil filler plug with new gasket.
Tightening torque:
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)
- Install the under cover.
Tightening torque:
7.8 ~ 9.8N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)