Repair Procedures: Removal

WARNING: This page is about a different car, the 2016 Hyundai Elantra GT and 2015 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the accelerator position sensor connector (A).

Fig 1: Identifying Accelerator Position Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the installation bolt (B), the nuts (C) and then remove the accelerator pedal module.

Fig 2: Identifying Accelerator Pedal Module Installation Bolt
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Identifying Accelerator Pedal Module Nut
Courtesy of HYUNDAI MOTOR AMERICA