Repair Procedures: Removal

Remove the valve body assembly.
(Refer to Valve body System - "VALVE BODY ")
Disconnect the input & output speed sensor connector (A).
Loosen the main connector bolt (B).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 1: Disconnecting Input & Output Speed Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the solenoid valve connector (A).
1. Press the lock
2. Pull up lever
Fig 2: Disconnecting Solenoid Valve Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve connector mounting clip (A).

Fig 3: Removing Solenoid Valve Connector Mounting Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve connector (A) by pushing down from the transaxle.

Fig 4: Removing Solenoid Valve Connector
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Replace the O-Ring (A) before reinstalling solenoid valve connector.
Fig 5: Replacing O-Ring
Courtesy of HYUNDAI MOTOR AMERICA