Blind Spot Detection - Right DTCS
BLIND SPOT DETECTION - RIGHT DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1101-17 | Battery Voltage High |
| DTC C1102-16 | Battery Voltage Low |
| DTC C120A-11 | LED Right Circuit Short to Ground |
| DTC C120B-15 | LED Right Circuit Short to Battery or Open |
| DTC C120C-11 | LED Left Circuit Short to Ground |
| DTC C120D-15 | LED Left Circuit Short to Battery or Open |
| DTC C1501-01 | Switch Failure |
| DTC C160A-88 | BSD Local CAN bus off |
| DTC C1611-87 | CAN Time-out EMS |
| DTC C1612-87 | CAN Time-out TCU |
| DTC C1613-81 | CAN signal error EMS |
| DTC C1616-88 | CAN Bus OFF (C-CAN) |
| DTC C1625-87 | CAN Time-out ABS_ESC (ESP) |
| DTC C1628-87 | CAN Time-out Cluster |
| DTC C1646-81 | CAN Message Failure - TCU |
| DTC C1671-81 | Signal Yaw Rate or Acceleration AX or Acceleration AY or Brakepressure State not valid |
| DTC C1675-81 | Signal WHEEL_FL or WHEEL-FR or WHEEL_RL or WHEEL_RR not Valid |
| DTC C170A-11 | Activation Switch LED Circuit Short to ground |
| DTC C170B-12 | Activation Switch LED Circuit short to battery or open |
| DTC C170C-04 | ECU Hardware error (REAR RIGHT) |
| DTC C170D-04 | ECU Hardware error (REAR LEFT) |
| DTC C180B-87 | CAN Time-Out CGW1 |
| DTC C2702-54 | Control Module Missing Calibration |
| DTC C2703-54 | Control Module Slave Missing Calibration |
| DTC C2706-42 | Software version LH_RH unmatching |