LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Veloster Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 3) - 1.6L GDI >> DTC P0133: O2 Sensor Circuit Slow Response (Bank 1/Sensor 1) >> System Inspection >> Check Fuel Pressure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Fuel Pressure

  1. IG KEY "OFF".
  2. Disconnect fuel pump relay from junction box in passenger compartment.
  3. Start engine and await until engine is off and then, IG "OFF".
  4. Connect fuel pump relay again.
  5. Connect fuel pressure gauge on the fuel filter with fuel pressure gauge adaptor.
  6. Start engine again and measure fuel pressure.

    Specification  : 480 ~ 500 kPa (4.9 ~ 5.1 kgf/cm2 , 69.6 ~ 72.5 psi)

  7. Is the fuel pressure normal?

    YES 

    NO 

    • Check any stuck of the valve in the fuel pressure regulator.
    • Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.