Audio assembly Replacement
CAUTION:
- A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Using a screwdriver or remover, remove the center facia panel (A).
- Disconnect the heater control unit connectors (A).
- After loosening the mounting screws, then remove the audio assembly (A).
- Disconnect the audio connectors (A).
- Installation is the reverse of removal.
NOTE:
- Make sure the connectors are connected in properly.
- Replace any damaged clips.