Denormalization (Memory reset)
Under conditions below, ECU turns to denormalized status. After denormalization, auto up and safety function shall not be operated. In order to make these function active again, ECU should go through the normalization process.
- Denormalization conditions:
- Continuous 15 times reverses
- Power off during motor operation
- Driver side door opened and window glass is at the bottom (hard stop position) with IGN on, IGN off? within 2 sec, IGN on → Press Manual Down switch 3 times within 5 sec → De-normalization
DENORMALIZATION CHART
| Door and Glass status | IGN status | Input time | IGN status | Switch input status | Switch input times | Normalization status | ||
|---|---|---|---|---|---|---|---|---|
| Re-input time | IGN status | Switch input | ||||||
| Driver side door opened, Window glass is bottom with IGN on (Hard stop) | IGN Off | T≤2 sec | IGN On | T≤5 sec | IGN On | Press and release Manual down switch | 3 times | Denormalization |