Select/Shift Cable Replacement

Remove the floor Interior console assembly.
(Refer to CONSOLE )
Remove the cover (A).

Fig 1: Locating Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the select cable (B) by removing the snap pin (A).

Fig 2: Locating Select Cable And Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 14.5 lb-ft)

Fig 3: Locating Shift Lever Assembly Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable (B) by removing the clip (A).

Fig 4: Locating Shift Cable And Clip (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Shift Lever (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the retainer (A) and nuts (B-2ea).
Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Fig 6: Locating Retainer And Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the select and shift cable assembly (B) after removing the pin (A).

Fig 7: Removing Pin, Select And Shift Cable Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the shift cable and select cable at cabin room.
Installation is the reverse of removal.