LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2018 >> Accent SE, Standard Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Manual Transaxle Control System >> Control Shaft Complete >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Set shift lever to 'N' position.
  2. Remove the Air Cleaner Assembly and Air Duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the Battery and Battery Tray.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Remove the Engine Control Module (ECM).

    (Refer to Engine Control System - "ENGINE CONTROL MODULE (ECM) ")

  5. Disconnect the shift cable (B) and the select cable (C) after removing the snap pin (A).
    G12598734Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the control shaft assembly (A) after loosening the bolts.

    Tightening Torque: 

    19.6 - 26.5 N.m (2.0 - 2.7 kgf.m, 14.5 - 19.5 lb-ft)

G12598735Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals