Repair Procedures: Installation
NOTE:
[In The Case Of Installing Used ECM]
[In the Case Of Installing New ECM]
- When replacing the ECM, the vehicle equipped with Immobilizer must be performed the procedure below.
[In The Case Of Installing Used ECM]
- Perform NEUTRALIZING OF ECM ("Neutral Mode") procedure with GDS. (Refer to "IMMOBILIZER SYSTEM " in BE procedure)
- Insert the key and turn it to the IGN ON and OFF position. Then the ECM key register process is completed automatically.
[In the Case Of Installing New ECM]
- Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
- Install in the reverse order of removal.
ECM Installation Nut:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
ECM Bracket Installation Bolt:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)