Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative (-) battery terminal.
Remove the glove box upper cover assembly.
(Refer to Body - "Glove Box Upper Cover Housing ")
Loosen the mounting screws and remove the crash pad center lower cover [LH](A).

Fig 1: Locating Crash Pad Center Lower Cover (LH)
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the A/C & heater controller unit (A).

Fig 2: Locating A/C & Heater Controller With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the A/C & heater controller connectors (A) and hose (B).

Fig 3: Locating A/C & Heater Controller Connectors And Hose
Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse the removal procedure.
Information
- Make sure the connector are connected in properly.
- Replace any damaged clips (or pin-type retainers).