Repair Procedures: Installation
WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable from the battery and wait for at least three minutes before beginning work.
- Connect the clock spring harness connector and horn harness connector to the clock spring.
- Set the center position by setting the marks between the clock spring and the cover into line. The mark (
) should be matched by turning the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.
- Install the steering wheel column shroud and the steering wheel.
(Refer to MDPS ASSEMBLY )
- Connect the driver airbag (DAB) module connector and horn connector, and then install the driver airbag (DAB) module on the steering wheel.NOTE: First, fix the wire on the fixing clip and then connect the connector.
- Connect the battery negative cable.
- After installing the driver airbag, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
- Make sure horn button works.