Repair Procedures: Installation

Install the snap pin (B).

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION:

Lug (A) must assemble upward.

Courtesy of HYUNDAI MOTOR AMERICA

When assembling the snap pin, be careful about the correct direction.

Courtesy of HYUNDAI MOTOR AMERICA

Install the shift cable (B) in the cable bracket (C).
Align the hole (E) in the manual control lever with the "N" position hole (F) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No: 09480-A3800).
Lightly tighten the nut (A) after connected the shift cable (B) in the manual control lever (D).
Push shift cable (B) lightly to "F" direction shown in the illustration to eliminate free play of shift cable.
Tighten the nut (A) to the specified torque.
Tightening torque

9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
Install the airbag module.
(Refer to "AIRBAG MODULE ")
Install the air duct (A).

Courtesy of HYUNDAI MOTOR AMERICA
Install the floor console assembly.
(Refer to "FLOOR CONSOLE ")
Install the air cleaner assembly.
(Refer to "AIR CLEANER ")
Install the battery and battery tray.
(Refer to "REMOVAL AND INSTALLATION ")
Install the air duct.
(Refer to "AIR CLEANER ")
CAUTION:
- Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.