Repair Procedures: Installation

Install the snap pin (B).

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION:

Lug (A) must assemble upward.

Courtesy of HYUNDAI MOTOR AMERICA

When assembling the snap pin, be careful about the correct direction.

The band portion (A) must point outwards.

Courtesy of HYUNDAI MOTOR AMERICA

Install the shift cable (B) in the cable bracket (C).
Align the hole (E) in the manual control lever with the "N" position hole (F) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No: 09480-A3800).
Lightly tighten the nut (A) after connected the shift cable (B) in the manual control lever (D).
Push shift cable (B) lightly to "F" direction shown to eliminate free play of shift cable.
Tighten the nut (A) to the specified torque.
Tightening torque

9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
Install the airbag module.
(Refer to Restraint - "DRIVER AIRBAG (DAB) MODULE AND CLOCK SPRING ")
Install the air duct (A).

Courtesy of HYUNDAI MOTOR AMERICA
Install the floor console assembly.
(Refer to Body - "FLOOR CONSOLE (EXCEPT HEV) ")
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Install the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Install the air duct.
(Refer to Engine Mechanical System - "AIR CLEANER ")
CAUTION:
- Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.