Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Put on gloves to prevent hand injuries.

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Take care not to scratch the body surface.

Remove the liftgate trim.
(Refer to Liftgate - "LIFTGATE TRIM ")
Disconnect the liftgate latch connector (A).

Fig 1: Disconnecting Liftgate Latch Connector
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting bolts, then remove the liftgate latch assembly (A).
Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 2: Removing Liftgate Latch Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.

NOTE:

Make sure the liftgate locks/unlocks and opens/closes properly.
Adjust the liftgate alignment.
Make sure the connectors are connected in properly.