LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2019 >> Santa Fe SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Airbag Modules And Clock Spring) >> Side Airbag (SAB) Module >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

WARNING: This page is about a different car, the 2020 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be sure to install the harness wires so they will not pinch or interfere with other parts.
NOTE:
  • Do not open the lid of the side airbag cover.
  • Make sure that the airbag assembly cover is installed properly. Improper installation may prevent a proper deployment.
  1. Disconnect the battery negative cable and wait for at least three minutes.
  2. Place a side airbag on the side airbag frame and tighten the side airbag mounting bolts.

    Tightening torque: 

    7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.7 - 8.7 lb-ft)

  3. Install a new seat back cover.

    (Refer to Body - "FRONT SEAT BACK COVER ")

  4. Install the front seat assembly, and then connect the side airbag harness connector.
  5. After installing the side airbag (SAB), confirm proper system operation:

    Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

  6. Install a front seat assembly.

    (Refer to Body - "FRONT SEAT ASSEMBLY ")

  7. Recline and slide the front seat forward fully, make sure the harness wires are not pinched or interfered by other parts.
  8. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals