Connector Pin Information
WARNING: This page is about a different car, the 2020 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
| No | Connector A | Connector B | Connector C |
|---|---|---|---|
| 1 | - | GND_ECU | Front wiper relay (Low)_output |
| 2 | - | PDW-F power_output | ESCL (+)_output |
| 3 | GND_Power | ESCL (-)_output | Start relay_output |
| 4 | PDW-R_Power_Output | Front wiper high relay_output | IGN1 relay_output |
| 5 | - | PDW-R WIND_output | Immobilizer antenna power_output |
| 6 | Rear washer switch_input | - | Immobilizer antenna ground_output |
| 7 | LIN4 (Rear seat remind) | - | - |
| 8 | P_CAN (Low) | Rear view switch_input | Interior1 antenna (+)_output |
| 9 | P_CAN (High) | - | Driver outside handle antenna (+)_output |
| 10 | - | Wheel speed sensor_input | - |
| 11 | B_CAN (Low) | - | Passenger outside handle antenna (+)_output |
| 12 | B_CAN (High) | 3rd line sheet belt indicator RH_output | - |
| 13 | SSB switch_input | Passenger seat belt indicator_output | Trunk interior antenna3 (+)_output |
| 14 | Driver handle antenna switch_input | Rear center seat belt indicator_output | Immobilizer K-Line |
| 15 | P position_input (AT) | - | Bumper antenna (+)_output |
| Clutch lock switch_input (MT) | |||
| 16 | Fog switch_input | LF searching_output | Interior antenna2 (+)_output |
| 17 | Light switch_input | Auto light sensor signal_input | IGN2_input |
| 18 | Front wiper INT volume switch_input | Auto light sensor power_output | IGN1_input |
| 19 | Multifunction switch_input | ATM solenoid_output | IGN2 relay_output |
| 20 | Right side mirror unfolding switch_output | Puddle pocket lamp_output | Battery_power |
| 21 | Right side mirror heater_output | - | Brake switch_input |
| 22 | Front washer switch_input | SSB ring illumination_output | Start feedback_input |
| 23 | Front wiper low switch_Input | piezo buzzer_output | Security indicator_output |
| 24 | LIN1 (PDW) | SSB symbol illumination_output | Interior1 (-)_output |
| 25 | LIN2 (Safety ECU) | - | Driver outside handle antenna (-)_output |
| 26 | LIN3 (Rain sensor) | Wiper power relay_output | - |
| 27 | PDW/PDW-R power_input | Rear seat belt indicator RH_output | Passenger outside handle antenna (-)_output |
| 28 | PDW_input | Rear seat belt indicator LH_output | ESCL COM |
| 29 | SSB switch1_input | 3rd line sheet belt indicator LH_output | Trunk Interior antenna3 (-)_output |
| 30 | ESCL unlock_input | Rear wiper relay_output | ESCL Enable_output |
| 31 | Passenger outside handle switch_input | Auto light sensor ground_output | Bumper antenna (-)_output |
| 32 | PDW switch_input | Wiper parking switch_input | Interior antenna2 (-)_output |
| 33 | Sun roof Status_input | ||
| 34 | Head lamp switch_input | ||
| 35 | Front wiper switch_input | ||
| 36 | Rear wiper switch_input | ||
| 37 | Mirror folding RH_output | ||
| 38 | Mirror RH VT_output |