LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2020 >> Elantra Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Airbag Modules And Clock Spring) >> Driver Airbag (DAB) Module And Clock Spring >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

WARNING: This page is about a different car, the 2019 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the driver airbag module.

    [Without Paddle Shift] 

    • Putting in a flat tool (Ø5 mm) into the guide hole and then press the spring.
    G12973207Courtesy of HYUNDAI MOTOR AMERICA

    [With Paddle Shift] 

    • Putting in a flat tool (Ø5 mm) into the guide hole (A) and then rotate it.
    G12973208Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • After inserting the tool, press the DAB fixed pin in the direction of the arrow as illustration below.
      G12973209Courtesy of HYUNDAI MOTOR AMERICA
  3. Release the connector locking pin, then disconnect the driver airbag module connector (A) and horn connector (B).
    G12973210Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • The removed airbag module should be stored in a clean, dry place with the pad cover facing up.
  4. Remove the steering wheel.

    (Refer to Steering System - "STEERING WHEEL ")

  5. Using a screwdriver or remover, separate the steering column shroud upper panel (A) from the steering column shroud lower panel.
    G12973211Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the steering column shroud lower panel (A) after loosening the screws.
    G12973212Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the clock spring (A) after disconnecting the clock spring connectors (B).
    G12973213Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals