Repair Procedures: Inspection
WARNING: This page is about a different variant/trim than selected.
Information
- Inspect the connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.
- Disconnect the parking switch connector.
- Turn Ignition "ON", & engine "OFF".
- Measure the output signal in each range (P, R, N, D).
SIGNAL CODE SPECIFICATION
| Signal | P | R | N | D |
|---|---|---|---|---|
| S1 | 18.30% | 47.50% | 64.60% | 81.70% |
| S2 | 81.70% | 52.50% | 35.40% | 18.30% |
PIN AND CONNECTION SPECIFICATION
| Pin | Connection information |
|---|---|
| 1 | Power (Ps, Ns) |
| 2 | Back-up lamp |
| 3 | Power (Back-up lamp) |
| 4 | Ps, Ns |
| 5 | Power (5V) |
| 6 | Ground (5V) |
| 7 | S1 |
| 8 | S2 |