Check auto cruise switch

IG key OFF.
Disconnect 'CRUISE REMOCON SWITCH' connector.

Measure resistance between 'Signal (Cruise sw)' terminal and 'Ground (Cruise sw)' terminals of 'CRUISE REMOCON SWITCH' harness connector.(Component side)

Specification:

Item	Resistance (Ω)
CRUISE MAIN switch	3.9 kΩ ± 5%
CANCEL switch	0 Ω ± 5%
COAST SET switch	220 Ω ± 5%
RESUME/ACCEL switch	910 Ω ± 5%

Is the measured value within specification?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Replace 'CRUISE REMOCON SWITCH' and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NOTE: There is a memory reset function on GDS that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others.