Common Specs & Procedure Index
VELOSTER COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | Refer to Tightening Torque chart under WHEN INSTALLING CONNECTING PARTS . Also refer to TIGHTENING TORQUES | ||
| Axle Nut/Hub Nut | |||
| Front | |||
| LH | 274.6-294.2 N.m (28.0-30.0 kgf.m, 202.5-217.1 lb-ft) | ||
| RH | 274.6-294.2 N.m (28.0-30.0 kgf.m, 202.5-217.1 lb-ft) | ||
| Battery | See BATTERY (1.6L) or | ||
| Brakes | |||
| Bleeding Sequence | BRAKE BLEEDING PROCEDURES | ||
| Disc/Drum Brakes | |||
| Service Specifications | SPECIFICATIONS | ||
| Torque | Refer to TIGHTENING TORQUES . | ||
| Charging | |||
| Generator | Refer to ALTERNATOR (1.6L) or | ||
| Torque | Refer to TIGHTENING TORQUES (1.6L)
or TIGHTENING TORQUES (2.0L) under ALTERNATOR. |
||
| Drive Belts | |||
| Adjustment | |||
| Generator Belt | Refer to ADJUSTMENT (1.6L) or | ||
| Engine Cooling | |||
| General Service Specifications | Refer to Cooling System in table under SPECIFICATIONS (1.6L) or | ||
| Radiator Cap Pressure | 13.51-17.78 psi | ||
| Thermostat R & I | THERMOSTAT (1.6L) or | ||
| Water Pump R & I | WATER PUMP (1.6L) or | ||
| Engine Mechanical | |||
| Compression | COMPRESSION PRESSURE INSPECTION (1.6L) or | ||
| Oil pressure (at 1, 000 RPM) | 1.6L :
100 kPa (1.0 kg/cm2
, 14.5 psi) or above 2.0L : 90.22 kPa (0.92 kg/cm2 , 13.09 psi) or above |
||
| Overhaul | SPECIFICATIONS (1.6L) or | ||
| Torque | TIGHTENING TORQUES (1.6L) or | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 1.6L :
52.8-55.7 Ft. Lbs. (71.5-75.5 N.m) 2.0L : 86.8 - 94.0 Ft. Lbs. (117.7 - 127.5 N.m) |
||
| Fuel System | |||
| Pressure Specification | 1.6L :
69.6 - 75.4 psi (480 - 520 kPa) 2.0L : 29.7 - 69.7 psi (343 kPa) |
||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST (LOW PRESSURE SYSTEM) (1.6L) or | ||
| Fuel Filter Location | In fuel pump assembly. | ||
| Fuel Filter R & I | FUEL FILTER (1.6L) or | ||
| Ignition | |||
| Firing Order & Cylinder Identification | 1-3-4-2. Also refer to FIRING ORDER & CYLINDER IDENTIFICATION . | ||
| Spark Plug | |||
| Type | 1.6L :
SILZKR8E8G 2.0L : ELR9IQP9+ |
||
| Gap | 1.6L :
0.0275 - 0.0314 in. (0.7 - 0.8 mm) 2.0L : 0.0314 - 0.0354 in. (0.8 - 0.9 mm) |
||
| Torque | 1.6L & 2.0L : 10.9-18.0 ft. lbs. (14.7-24.5 N.m) | ||
| Starting | |||
| Starter | See STARTER (1.6L) or | ||
| Torque | 1.6L & 2.0L : 49.0-63.7 N.m (5.0-6.5 kgf.m, 36.2-47.0 lb-ft) | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT | ||
| Torque | TIGHTENING TORQUE | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 79.6-94.0 ft. lbs. (107.9-127.5 N.m) | ||