Removal And Installation

When the oil sensor signal fault occurs, refer to the DTC INDEX .

1. Disconnect the battery (-) terminal.
2. Drain the engine oil.

   (Refer to Lubrication System - "ENGINE OIL ")

3. Remove the oil level sensor (A) from the oil pan after disconnecting the connector.

   Tightening torque: 

   8.8 - 9.8 N.m (0.9 - 1.0 kgf.m, 6.5 - 7.2 lb-ft)

   Courtesy of HYUNDAI MOTOR AMERICA

   NOTE:

   • When installing, replace with new gaskets.
4. Install in the reverse order of removal.