Repair Procedures: Removal
- Perform the line pressure removal mode off procedure by using the diagnostic tool.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "AIR CLEANER REPAIR PROCEDURES ")
- Disconnect the RCV control solenoid valve connector (A) and booster pressure sensor connector (B).
- RCV solenoid valve hose (A) and then separate the intercooler outlet hose (B).
- Disconnect the TCM connector (A).
- Loosen the TCM upper mounting bolts (A).
Tightening torque:
9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)
- Remove the engine room under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
- Remove the wiring bracket (A) after loosening the mounting bolt.
- Loosen the TCM mounting bolts (A), (B) and then remove the TCM (C).
Tightening torque:
(A): 9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)
(B): 7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)
NOTE:- Be careful not to damage the TCM pin part (A) when removing the TCM assembly.