Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| P0601-00 | Internal Control Module Memory Check Sum Error |
| P0705-00 | Transmission Range Sensor Circuit Malfunction |
| P0706-00 | Shift Cable alignment error between TGS Lever and Transmission Range Sensor |
| P0711-00 | Transmission Fluid Temperature Sensor 'A' Circuit Range/Performance |
| P0712-00 | Transmission Fluid Temperature Sensor 'A' Circuit Low Input |
| P0713-00 | Transmission Fluid Temperature Sensor 'A' Circuit High Input |
| P0717-00 | Input/Turbine Speed Sensor 'A' Circuit No Signal |
| P0721-00 | Output Speed Sensor Circuit Range/Performance |
| P0722-00 | Output Speed Sensor Circuit No Signal |
| P0729-00 | Gear 6 Incorrect Ratio |
| P0731-00 | Gear 1 Incorrect Ratio |
| P0732-00 | Gear 2 Incorrect Ratio |
| P0733-00 | Gear 3 Incorrect Ratio |
| P0734-00 | Gear 4 Incorrect Ratio |
| P0735-00 | Gear 5 Incorrect Ratio |
| P0741-00 | Torque Converter Clutch Circuit Performance or Stuck Off |
| P0743-00 | Torque Converter Clutch Circuit Electrical |
| P0748-00 | Pressure Control Solenoid Valve (VFS) 'A' Electrical |
| P0753-00 | Shift Control Solenoid Valve 'A' Electrical (UD/B) |
| P0758-00 | Shift Control Solenoid Valve 'B' Electrical (2-6/B) |
| P0763-00 | Shift Control Solenoid Valve 'C' Electrical (35R/C) |
| P0768-00 | Shift Control Solenoid Valve 'D' Electrical (OD/C) |
| P0773-00 | Shift Control Solenoid Valve 'E' Electrical (SS-A) |
| P07FF-00 | SBW SYSTEM ERROR |
| P0880-00 | TCM Power Signal Error Open/Short (GND) |
| P1602-00 | No EOL Data |
| P1774-00 | Speed Command PWM Line |
| P1775-00 | OPU Status Line |
| P1776-00 | Electric Oil Pump Hall IC Sensor failure |
| P1777-00 | OPU (Oil Pump control Unit) Power Circuit Fault |
| P1778-00 | Engine Clutch VFS Fail |
| P1784-00 | EOP 3-Phase Wiring line open |
| P1985-00 | EOP-OPU Driving Performance |
| P1987-00 | OPU (Oil Pump control Unit) High Voltage Interlock Circuit Open |
| P1988-00 | OPU (Oil Pump control Unit) Signal Circuit Fault |
| P1990-00 | OPU (Oil Pump control Unit) Input High Voltage Wiring line open |
| P2709-00 | Shift Control Solenoid Valve 'F' Electrical (SS-B) |
| U0001-00 | High Speed CAN Communication Bus off |
| U0100-00 | Lost Communication With ECM/PCM 'A' |
| U0103-00 | CAN TIME OUT (E-Shifter) (SBW) |
| U0103-08 | CAN TIME OUT (E-Shifter) (SBW) |
| U0110-00 | Lost Communication with Drive Motor Control Module 'A' |
| U0111-00 | Lost Communication With Battery Energy Control Module 'A' |
| U0293-00 | Lost Communication With Hybrid Powertrain Control Module |
| U1001-00 | High Speed CAN Communication Bus (H-CAN) |
| U1002-00 | Lost Communication with ECM (H-CAN) |
| U1004-00 | Lost Communication with Hybrid Powertrain Control Module (H-CAN) |
| U1006-00 | Lost Communication with Battery Energy Control Module 'A' (H-CAN) |
| U1007-00 | CAN Timeout OPU on P-CAN |
| U1117-88 | High Speed CAN2 Communication |