DTC Information and Inspection: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
Case 1	Main Action	Level 2 process monitoring	Contact resistance in connectors Faulty ECM
	Prerequisite Condition	Ignition Switch is turned "ON" or engine is running with speed over 32 rpm.
	Threshold Value	Actual value is higher or lower than allowable range.
	Diagnosis Time	0.48 Seconds
Case 2	Main Action	Level 2 process monitoring
	Prerequisite Condition	Engine is running with speed over 32 rpm.
	Threshold value	Torque difference between actual and set-point value is higher than allowable range.
	Diagnosis Time	0.48 Seconds
Case 3	Main Action	Level 2 process monitoring
	Prerequisite Condition	Engine is running with speed over 32 rpm.
	Threshold Value	Engine speed is too high when ETC limp home is active. Engine speed is higher than 1760 rpm.
	Diagnosis Time	0.48 Seconds
Case 4	Main Action	Check RAM Area/communication connections
	Prerequisite Condition	Ignition Switch is turned "ON".
	Threshold value	RAM test/Checksum/SPI communication failure
	Diagnosis Time	0.1 Seconds
Case 5	Main Action	Level 3 process monitoring
	Prerequisite Condition	Ignition Switch is turned "ON".
	Threshold value	RAM/ROM error on micro-controller checksum check RAM/ROM error on communication between main controller and monitoring unit Process monitoring test calculation failed
	Diagnosis Time	Immediately
MIL On Condition		1st driving cycle