(Position Sensor Removal And Installation)

ABBREVIATED PROCEDURE

Work		H/W	Tightening torque N.m (kgf.m/lb-ft)	SST/Equipment	Chemical	etc
Removal
1	Disconnect the battery (-) terminal	-	-	-	-	-
2	Remove the electronic shift actuator (Refer to Automatic Transaxle Control System - "ELECTRONIC SHIFT ACTUATOR ")	-	-	-	-	-
3	Disconnect the position sensor connector	-	-	-	-	-
4	Remove the position sensor after removing the bolts	-	-	-	-	-
Installation
1	Check that the shaft is in the "N" position	-	-	-	-	-
2	Lightly tighten the bolts after installing the position sensor	-	-	-	-	-
3	Install the service special tool (09459-4G200) from position sensor.	-	-	-	-	-
4	Tighten the position sensor mounting bolts with specified torque.	Bolt	9.8 - 11.8 (1.0 - 1.2/7.2 - 8.7)	-	-	-
5	Remove the service special tool (09459-4G200)	-	-	-	-	-
6	Connect the position sensor connector	-	-	-	-	-
7	Install the electric shift actuator (Refer to Automatic Transaxle Control System - "ELECTRONIC SHIFT ACTUATOR ")	Bolt	20.6 - 26.5 (2.1 - 2.7/15.2 - 19.5)	-	-	-
8	Install the battery and battery tray (Refer to Engine Electrical System - "1.6L 12V BATTERY ")
9	Install the air duct and the air cleaner assembly (Refer to Engine Mechanical System - "AIR CLEANER ")	-	-	-	-	-
10	Check that operating surely at each range of the position sensor corresponding to each position of electric shift button	-	-	-	-	-