(SBW Control Unit (SCU) Removal And Installation)
ABBREVIATED PROCEDURE
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Disconnect the battery (-) terminal | - | - | - | - | - |
| 2 | Disconnect the SBW(Shift By Wire) control unit connector | - | - | - | - | - |
| 3 | Remove the SBW(Shift By Wire) control unit and bracket assembly at the same time after removing the bolts | Bolt | 9.8 - 11.8 (1.0 - 1.2/28.9 - 33.9) | - | - | - |
|
||||||
| Install in the reverse order of removal | - | |||||