Repair Procedures: Cleaning
- Remove the ETC Module.
(Refer to ETC System - "REMOVAL ")
- Clean the pollutant in the throttle body using a soft cloth moistened with cleaning fluid.NOTE:
- Do not spray cleaning fluid directly onto ETC. Use a lint free cloth moistened with cleaning fluid.
- Be careful not to clean the coating fluid around the shaft. If coating fluid is removed, idling control failure might occur by foreign substance inflow or excessive air leakage.
- Remove the ETC Module.
(Refer to ETC System - "INSTALLATION ")
- Reset the ECM adaptive values after replacing the ETC.
- Perform the ETC learning procedure.
(Refer to ETC System - "ADJUSTMENT ")