(Power Net Domain Controller (PDC) Removal And Installation)
WARNING: This page is about a different car, the 2024 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
ABBREVIATED PROCEDURE
| Work | H/W | Tightening torque N.m (kgf.m/lb-ft) | SST/Equipment | Chemical | etc | |
|---|---|---|---|---|---|---|
|
||||||
| 1 | Disconnect the battery (-) terminal | - | - | - | - | - |
| 2 | Remove the crash pad lower panel (Refer to Crash Pad - "CRASH PAD LOWER PANEL ") |
- | - | - | - | - |
| 3 | Disconnect the powernet domain controller connector | - | - | - | - | - |
| 4 | Remove the powernet domain controller | Nut | 5.9 - 8.8 (0.6 - 0.9/4.3 - 6.5) | - | - | - |
| 5 | Disconnect the powernet domain controller connector | - | - | - | - | - |
| 6 | Remove the wiring clip | Clip | - | - | - | - |
|
||||||
| Install in the reverse order of removal | - | |||||
|
||||||
|
||||||