October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Test 7
- Unplug 12-pin connector from control unit. See Figure
. Control unit is located in trunk, on right side. Connect jumper wire between connector terminal No. 15 and ground. If hazard lights do not flash, go to next step. If hazard lights flash, replace control unit.
- Unplug remote control relay No. 1. See Fig 1
. Relay is located in trunk, on right side.
- Check for continuity between control unit connector terminal No. 15 and relay connector terminal No. 15. If continuity exists, check relay and associated wiring. If continuity does not exist, repair wire between specified connector terminals.