Cut-Off Circuit Test
- Turn ignition on. Turn cruise control main switch on. Connect voltmeter between cruise control module harness connector terminals No. 3 and 5. See Figure and Figure. If voltage is present with brake pedal and clutch pedal (M/T) released or when transmission is not in Park or Neutral (A/T), go to next step. If voltage is not present, go to step 3).
- Check voltage between cruise control module connector terminals No. 3 and 11. With ignition switch in ON position and brake pedal depressed, voltage should be present. If voltage is not present, check brakelight switch circuit.
- If voltage was not present in step 1), check brake cancel, inhibitor and clutch switches. Adjust or replace as necessary. See BRAKE CANCEL, BRAKELIGHT & CLUTCH SWITCHES under ADJUSTMENTS. Check inhibitor relay and switch and theft warning relay.