LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 1994 >> Q45 Base >> Repair and Diagnosis >> Engine Performance >> Sensor Range Charts >> Engine Controls - Sensor Operating Range Charts >> Sensor Range Charts
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Sensor Range Charts

Sensor operating range information can help determine if a sensor is out of calibration. An out-of-calibration sensor may not set a trouble code, but it may cause driveability problems.

NOTE: Unless stated otherwise in test procedure, perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance.
COOLANT TEMPERATURE SENSOR RESISTANCE (1)

Temperature - °F (°C) Ohms
68 (20) 2100-2900
122 (50) 680-1000
176 (80) 300-330
(1) Measure resistance across sensor terminals.
EGR TEMPERATURE SENSOR RESISTANCE (1)

Temperature - °F (°C) Ohms
212 (100) 76,770-93,830
(1) Heat sensor in water and measure resistance across sensor terminals.
FUEL TEMPERATURE SENSOR RESISTANCE (1)

Temperature - °F (°C) Ohms
68 (20) 2100-2900
122 (50) 680-1000
176 (80) 300-330
(1) Measure resistance between sensor terminals at pressure regulator.
HEATED OXYGEN SENSOR VOLTAGE (1)

Condition Volts
Lean 0-0.3
Rich 0.6-1.0
(1) Measure voltage between oxygen sensor terminal and ground, voltage should continuously change. Measure heater resistance between terminals "A" and "C" at sensor. Resistance should be 3-1000 ohms.
CLOSED THROTTLE POSITION SWITCH CONTINUITY (1)

Position Reading
Closed Throttle Continuity
Open Throttle No Continuity
(1) Check continuity between terminals No. 2 and 3 at sensor. See Fig 1 .
THROTTLE POSITION SENSOR RESISTANCE (1)

Position Ohms
Closed Throttle 700
Partially Open 700-5000
Wide Open Throttle 5000
(1) Measure resistance between terminals No. 4 and 5 at sensor. See Fig 1 .
MASS AIRFLOW SENSOR VOLTAGE (LOW RPM) (1)

Application Terminal No Volts
Q45 "1" 1.0-1.4
(1) Measure voltage between ground and indicated airflow meter terminal with engine idling at normal operating temperature.
MASS AIRFLOW SENSOR VOLTAGE (HIGH RPM) (1)

Application Terminal No Volts
Q45 "1" 1.4-1.9
(1) Measure voltage between ground and indicated airflow meter terminal with engine running at 2000 RPM at normal operating temperature.
Fig 1: Throttle Position Sensor/Closed Throttle Switch Terminal ID
G90A15222Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals