Programming Remote Control
WARNING: This page is about a different car, the 1996 Infiniti G20. However, it is still accessible from the selected car via links, so may be relevant.
- New ID code has to be manually entered whenever replacing or adding additional remote control(s). To enter ID code, perform steps 2) and 3).
- Open trunk. Close and lock all doors. Erase original ID code(s) by inserting and removing key from ignition switch more than 6 times within 10 seconds.
- Unlock and lock driver's door inside lock lever once. Push lock button on new remote control once. ID code for new remote control has now been entered.
- Repeat steps 2) and 3) to enter additional remote control ID code(s). A maximum of 4 remote control ID codes can be entered. If same ID code is entered more than once, the entry is ignored. To exit programming (ID entry) mode, open any door.