LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 1995 >> Q45 a >> Repair and Diagnosis (Single Page) >> Steering >> Power Steering >> Steering System - Electronic Power Steering >> System Testing >> Procedure No. 1 Heavy Steering Operation During Stationary Turns >> Check Power Steering Control Unit For Proper Operation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Power Steering Control Unit For Proper Operation

  1. Turn ignition on. Measure voltage between ground and power steering control unit connector terminal No. 1. See Figure . Voltage should be 12 volts. If voltage is as specified, go to next step. If voltage is not as specified, repair ignition power circuit for open or short circuit.
  2. Disconnect solenoid valve 2-pin connector. Solenoid valve is attached to steering gear. Measure resistance between solenoid valve connector terminals. Resistance should be 4-6 ohms. If resistance is as specified, go to next step. If resistance is not as specified, replace solenoid valve.
  3. Ensure power steering control unit connector is properly connected. Check if heavy steering operation occurs during stationary turns. If heavy steering operation occurs during stationary turns, replace power steering control unit.
scientia non olet · About LEMON Manuals