Programming Remote Control
- New ID code has to be manually entered whenever replacing remote control or LCU 05, or adding additional remote control(s). To enter ID code, perform steps 2) and 3).
- Close and lock all doors. Erase original ID code(s) by inserting and removing key from ignition switch more than 6 times within 10 seconds. Hazard warning lights should flash twice.
- Turn ignition switch to ACC position. Push lock button on new remote control once. Hazard warning lights should flash twice, indicating ID code for new remote control has been entered.
- To enter additional remote control ID code(s), unlock driver's door and then lock it using door lock knob. Press lock button on new remote control once to enter ID code.
- A maximum of 4 remote control ID codes can be entered. If same ID code is entered more than once, the entry is ignored even though hazard warning lights will still flash twice. To exit programming (ID entry) mode, open driver's door.