DTC Confirmation Test (Using Generic Scan Tool)
NOTE:
Use the following test to check overall function of HO2S1 circuit. During this test, 1st trip DTC may not be confirmed.
CAUTION:
DO NOT use ECM ground terminals when measuring voltage.
- Start engine and warm to normal operating temperature. Measure voltage between ground and ECM terminal No. 91 (bank 1) or No. 92 (bank 2) by backprobing. See Figure and Figure .
- While observing voltmeter, increase engine speed to 2000 RPM. Voltage should not remain in the .2-.4 volt range. If voltage is not as specified, go to DIAGNOSTIC PROCEDURE . If voltage is as specified, system is okay at this time.