DTC Confirmation Test (Using CONSULT-II)
- Start engine and warm to normal operating temperature.
- Select HO2S1 (B1) P0134 or HO2S1 (B2) P0154 in DTC WORK SUPPORT mode with CONSULT-II.
- Press START.
- Allow engine to idle for at least 3 minutes.NOTE: DO NOT exceed 3600 RPM. If engine speed exceeds 3600 RPM, return to step 4 .
- When the following conditions are met, TESTING will be displayed on CONSULT-II screen:
- ENG SPEED: 1400-2600 RPM.
- Vehicle speed: more than 43 MPH.
- B/FUEL SCHDL: 2-12 msec.
Maintain conditions continuously until TESTING changes to COMPLETED (it will take 10-60 seconds). If TESTING is not displayed after 5 minutes, retry from step 2 .
- Press SELF-DIAG RESULTS. If NG is displayed, go to DIAGNOSTIC PROCEDURE . If OK is displayed, system is okay at this time.