Key Switch Insert Signal Check

CHECK KEY SWITCH INPUT SIGNAL
With CONSULT-II
- Check Key switch ( "IGN KEY SW") in "DATA MONITOR" mode with CONSULT-II.
  1. When key is inserted to :IGN KEY SW ON
  2. ignition key cylinder
  3. When key is removed :IGN KEY SW OFF
  4. to ignition key cylinder
Without CONSULT-II
1. Disconnect the BCM connector.
2. Check voltage between BCM harness connector M4 terminal 69 (PU/W) and body ground.
  1. Condition of key switch Voltage [V]:
  2. key is inserted : Approx. 12
  3. key is removed : Approx. 0
  Fig 1: Checking Key Switch Input Signal Without Consult-II
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK >> Key switch is OK.
2. NG >> GO TO 2.
CHECK KEY SWITCH CIRCUIT
1. Remove the key from the ignition key cylinder.
2. Disconnect the key switch connector.
3. Check continuity between BCM harness connector M4 terminal 69 (PU/W) and key switch harness connector terminal 4 (PU/W).
  1. Continuity should exist.
  Fig 2: Checking Key Switch Circuit
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK >> GO TO 3.
2. NG >> Repair or replace harness.
CHECK KEY SWITCH (INSERT)
1. Check continuity between key switch harness connector terminals 3 and 4.
  
  Fig 3: Checking Key Switch (Insert) (1 Of 2)
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 4: Checking Key Switch (Insert) (2 Of 2)
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK >> Inspection end.
2. NG >> Replace switch.