Self-Diagnostic Results

Touch SELF-DIAG RESULTS on SELECT DIAG MODE.
Self-diagnosis results should be displayed. See DISPLAY ITEM LIST table.

DISPLAY ITEM LIST

CONSULT-II Display

Malfunction Is Detected When:

CAN COMM CIRC (U1000)

In CAN Communication

METER COMM CIRC (B2202)

⁽¹⁾ In Communication Between Combination Meter & Unified Meter & A/C Amp.

VEHICLE SPEED CIRC (B2205)

⁽²⁾ An Erroneous Speed Signal Is Input For One Second.

⁽¹⁾	CAUTION: Even when there is no malfunction on CAN communication system, malfunction may be misinterpreted when battery has low voltage (when maintaining 7-8 volts for about 2 seconds) or fuse No. 19 (10-Amp) is disconnected.

⁽²⁾	CAUTION: Even when there is no malfunction on speed signal system, malfunction may be misinterpreted when battery has low voltage (when maintaining 7-8 volts for about 2 seconds).

NOTE: TIME keeps showing zero after returning to normal condition only in the case that malfunction history of CAN COMM CIRC (U1000) remains because of low tire pressure warning control unit, display control unit (without NAVI) malfunction.

TIME (on display), indicates the condition of the self-diagnosis results judged by each signal unit.

Normal - In case of operating properly at the present in spite of having malfunction in the past, then TIME indicates 1-63.
Malfunction - Soon after detecting malfunctions by self-diagnostics or current malfunction, zero is indicated.

After returning to normal condition, every time when ignition switch is turned to OFF from ON, time will be added like "1" to "2" to "3"..."63", and when the key operation is performed 64 times, the result of the self-diagnostics will be erased. And if any malfunction is detected again, zero will be indicated.