DTC Confirmation Procedure
NOTE:
If DTC confirmation procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
NOTE:
Steps 3 and 4
may be conducted with the drive wheels raised and supported in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to raise the vehicle.
Using CONSULT-II Or GST
- Start engine (TCS switch or VDC switch OFF)
- Select DATA MONITOR mode.
- Drive vehicle for at least 5 consecutive seconds at a speed of more than 19 MPH with selector lever in suitable position. If DTC is detected, go to DIAGNOSTIC PROCEDURE . If DTC is not detected, go to next step.
- Drive the vehicle for at least 5 consecutive seconds at a speed of more than 19 MPH, selector lever in suitable position and brake pedal depressed for more than 5 seconds without decreasing vehicle speed.
- If DTC is detected, go to DIAGNOSTIC PROCEDURE . If DTC is not detected, system is okay at this time.