DTC Confirmation Test (Using Generic Scan Tool)
- Start engine. Drive vehicle according to driving patterns. See SYSTEM READINESS TEST under SELF-DIAGNOSTIC SYSTEM.
- Stop vehicle. Select MODE 1. If SRT of EVAP system is not set yet, go to next step. If SRT of EVAP system is set, result will be okay.
- Turn ignition switch off and wait at least 10 seconds.
- Start engine. Drive vehicle again according to driving patterns. See SYSTEM READINESS TEST under SELF-DIAGNOSTIC SYSTEM.
- Stop vehicle. Select MODE 3. If P0442 is displayed on screen, go to DIAGNOSTIC PROCEDURE . If P0441 is displayed, go to DIAGNOSTIC PROCEDURE under DTC P0441. If P0441 or P0442 are not displayed, go to next step.
- Select MODE 1. If SRT of EVAP system is set, result is okay. If SRT of EVAP system is not set, go to step 4 .