CONSULT-II Basic Operation

WARNING: This page is about a different car, the 2003 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

With ignition switch in OFF position, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector. See Fig 1. Turn ignition switch to ON position.
Touch START (NISSAN BASED VHCL).
Touch METER A/C AMP on SELECT SYSTEM screen. If METER A/C AMP is not indicated, check data link connector circuits. See UNIFIED METER & A/C AMP in appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT.
Select SELF-DIAG RESULTS or DATA MONITOR.

Fig 1: Locating DLC

Courtesy of NISSAN MOTOR CO., U.S.A.