Removal And Installation Of BCM: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the dash side finisher. Refer to , "BODY SIDE TRIM " .
Disconnect BCM connector.
Remove bracket mounting screws (3) to remove BCM and fuse block with bracket.

Fig 1: Locating Bracket Mounting Screws (3)
Courtesy of NISSAN MOTOR CO., U.S.A.
Raise the pawl of fuse block and remove bracket from fuse block to remove BCM.

Fig 2: Locating Pawl Of Fuse Block For Raising
Courtesy of NISSAN MOTOR CO., U.S.A.