DTC Confirmation Test (Using CONSULT-II)
NOTE:
If a DTC confirmation test has been previously performed, turn ignition off and wait at least 10 seconds before performing next DTC confirmation test.
- Start engine and warm it to normal operating temperature.
- Turn ignition off and wait at least 10 seconds.
- Turn ignition on.
- Select DATA MONITOR mode with CONSULT-II.
- Ensure FUEL T/TEMP SE value is more than 32°F (0°C).
- Start engine and wait 20 seconds.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.