DTC Confirmation Test
NOTE:
If a DTC confirmation test has been previously performed, turn ignition off and wait at least 10 seconds before performing next DTC confirmation test.
- Turn ignition on and wait at least one second.
- Select DATA MONITOR mode with scan tool.
- Start engine and let it idle for one second.
- Turn ignition off, wait at least 10 seconds, and then turn ignition on.
- Repeat steps 3 and 4 a total of 4 times.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.