DTC Confirmation Test (Using CONSULT-II)
- Start engine. Read VHCL SPEED SE in DATA MONITOR mode with CONSULT-II. VHCL SPEED SE should be able to exceed 6 MPH when drive wheels are rotating at 6 MPH or more. If operation is as specified, go to next step. If operation is not as specified, go to DIAGNOSTIC PROCEDURE
.
- Select DATA MONITOR mode with CONSULT-II. Warm engine to normal operating temperature. Maintain the following conditions for at least 10 consecutive seconds:
- ENG SPEED: more then 1800 RPM.
- COOLAN TEMP/S: more than 158°F (70°C).
- B/FUEL SCHDL: 5.5-14.0 msec (A/T) or 6.0-14.0 msec (M/T).
- PW/ST SIGNAL: OFF.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE
. If 1st trip DTC is not detected, system is okay at this time.