DTC Confirmation Procedure

WARNING: This page is about a different car, the 2004 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11V at ignition switch ON.

WITH CONSULT-II

Turn ignition switch ON.
Select DATA MONITOR mode with CONSULT-II. See Figure .
Wait at least 5 seconds.
If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .

WITH GST

Follow the procedure WITH CONSULT-II.