DTC Confirmation Procedure

WARNING: This page is about a different car, the 2004 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10V at idle.

With CONSULT-II

Turn ignition switch ON
Select DATA MONITOR mode with CONSULT-II. See Figure .
Start engine and let it idle for 1 second.
If DTC is detected, go to DIAGNOSTIC PROCEDURE .

With GST

Follow the procedure WITH CONSULT-II.